1. Before each start, each movable part must be lubricated once. (Manipulator, manipulator guide rail, mold opening and closing guide rail)
2. The swing arm can be added once every (3-4) days. The large chain and small chain of the heating machine can be used once a month.
3. Before production, check whether the moving parts are firm and whether the screws are loose, especially the parts with greater impact and whether the belt transmission parts are abnormal.
4. Regularly check whether the main engine reducer and heater reducer are short of oil. The main engine bearing can be added once a month (2-3).
Check whether the high-pressure air source, low-pressure air source, power source, and water source are normal.
5. Check the emergency stop switch, safety door switch and protection device to check whether the switch is normal.
6. Check whether the heating head enters the embryo and the embryo falls are working properly. If the embryo insertion is not in place, you can adjust the nut of the embryo embossing device.
7. Check whether the lamp tube is damaged or broken. Must be replaced in time.
