1. The bottle cannot be taken out of the mold after it is blown.
First, open the mold, open and close the mold manually, if it is normal, run it in the dry running state, if it is also normal.
Please check your exhaust time setting. If the exhaust setting is normal and it fails every time you blow the bottle, then it can be judged that the exhaust valve is the problem. Please open the exhaust valve to check the condition of its spring and seal (this Another phenomenon of this kind of failure is that the exhaust sound is relatively loud or there is a sound of dirty exhaust).
If you encounter a situation where many molds are produced normally and accidentally cannot open the mold, please check whether the clamping pin has a segmented screw in it. In addition, please check whether the clamping force is too large. If it is too large, you should follow Standard readjustment.
2. The bottle is always pinched
Whether the position of the manipulator is misaligned.
3. Two manipulators collide
In this case, you need to manually reset the manipulator again, which is caused by misalignment.
